The short answer
The Minolta X-700 takes two 1.5V button cells in the LR44 / SR44 size, or one 3V CR-1/3N lithium cell in their place. The manual lists all three:
| Chemistry | Names on the pack | How many | Notes |
|---|---|---|---|
| Silver oxide | SR44, 357, 303, S76, EPX76 | 2 | 1.55V each. Holds a steady voltage until nearly empty. |
| Alkaline | LR44, A76 | 2 | 1.5V each. Cheapest and sold almost everywhere. |
| Lithium | CR-1/3N | 1 | 3V, takes the space of both button cells. |
The manual also says never use 1.35V mercury cells (MR44, EPX-675) and don’t mix cell types, brands or ages.
Which one should you buy?
SR44 silver oxide is the best everyday choice. Have Camera Will Travel says SR44 holds a steadier voltage and lasts longer than LR44. Butkus.org says the same about silver oxide in general, for a small extra cost.
LR44 alkaline works fine too, and the manual lists it. A Photo.net owner points out that the X-700 runs happily on cheap LR44s. Their voltage sags as they age, so replace them at the first sign of trouble.
CR-1/3N lithium is a single cell that replaces the pair. The manual lists it. It costs more and is harder to find in shops.
Ken Rockwell’s list of cells also includes AG13, and Butkus.org treats AG13 as the same size as LR44.
Does the X-700 work without batteries?
No. Have Camera Will Travel’s chart sums it up: electronic shutter, no battery, no pictures. Posters in a Photo.net thread confirm that even B is electronic on the X-700. The manual adds that the shutter won’t release when the voltage is too low.
This trips people up because the Minolta XD-11 has mechanical “O” and B settings that work without power. The X-700 doesn’t.
Carry spares. The manual lists a slide-on spare battery holder that fits on the strap as a standard accessory.
How to fit the batteries
- Use a coin to unscrew the battery-chamber cover on the bottom of the camera. Mike Eckman describes it as the round opening on the base plate.
- Wipe the battery contacts with a clean, dry cloth.
- Hold the cells by their edges, so skin oil doesn’t get on the flat faces.
- Put the cells into the sleeve inside the cover, plus (+) side out, as the manual says.
- Screw the cover back on firmly.
How to check the batteries
- Battery check: the manual says you check the cells by touching the button. If the finder LEDs don’t light, the cells are near the end.
- Low battery: Ken Rockwell notes the X-700 shows a low battery by switching off the finder LEDs, even though the camera may keep working for a while. Once the voltage drops further, the manual says the shutter locks.
- Power saving: Mike Eckman says touching the shutter release wakes the meter for about 15 seconds, then it goes back to sleep. The main switch around the speed dial turns the camera fully off. Switch it off in your bag, so the release can’t get pressed by accident.
Fresh batteries, still dead?
If you fit new cells and the X-700 still won’t fire, the batteries probably aren’t the problem. The X-700 is known for capacitor failure. Mike Eckman explains that Minolta switched two capacitors in the metering system from tantalum to electrolytic types in the mid-1980s, and the electrolytic ones are more likely to fail with age.
Our Minolta X-700 page describes the symptoms (LEDs light on a half press, then go out and the shutter won’t fire) and the serial-number rule of thumb. Before blaming the capacitors, check two cheaper things:
- Corroded contacts. A leaked cell leaves white or green crust. Clean it off and try again.
- Mixed or weak cells. Fit two new cells of the same type, from the same pack.
Remove the batteries if you store the camera for months. A leaking cell can damage the circuit.
Other Minolta cameras that take the same cells
Have Camera Will Travel lists two SR44-size cells for these Minolta bodies, from their manuals:
- Minolta X-570: batteries required for every speed
- Minolta XG-M: SR44 or LR44
- Minolta XD-11: SR44; “O” and B are mechanical
- X-300 and X-370: SR44; the chart notes lithium cells may struggle in the cold on the X-370
The Minolta SRT 101 is different: it was made for a 1.35V PX625 mercury cell.
FAQ
What battery does the Minolta X-700 take? Two 1.5V LR44 (alkaline) or SR44 (silver oxide) cells, or one 3V CR-1/3N lithium cell.
LR44 or SR44 for the X-700? Both work. SR44 holds its voltage better and lasts longer; LR44 is cheaper.
Can the Minolta X-700 shoot without batteries? No. Every speed, including B, is electronic.
Why won’t my X-700 work with new batteries? Check for corroded contacts first. If the LEDs light on a half press but the shutter won’t fire, the capacitor fault is the likely cause.
How do I know the X-700 batteries are low? The finder LEDs stop lighting. When the voltage drops further, the shutter locks.