Skip to content
lastroll

Battery · 1.5V nominal (1.55V silver oxide)

Pentax K1000 Battery: Which One It Takes, LR44 vs SR44 and How to Check It

The Pentax K1000 takes one 1.5V LR44 or SR44 button cell, for the meter only. LR44 vs SR44, how to fit and test it, and why to keep the lens cap on.

Reviewed Nov 21, 20264 min read

The short answer

The Pentax K1000 takes one 1.5V button cell in the LR44 / SR44 size. It’s the same small coin-shaped cell sold in most supermarkets and camera shops. Any of these will fit:

Chemistry Common names on the pack Notes
Silver oxide SR44, 357, 303, S76, EPX76 The type Pentax specified. Holds a steady voltage until it’s nearly empty.
Alkaline LR44, A76 Cheaper and sold almost everywhere. Voltage drops gradually as it runs down.

Wikipedia lists A76, S76, LR44, SR44 and silver-oxide 357 or 303 as suitable. Have Camera Will Travel quotes the manual of the K1000’s sibling, the KM, which asks for a 1.5V silver-oxide Eveready S76E or Mallory MS76H. Today that’s an SR44.

What the battery does (and doesn’t do)

The battery only powers the light meter. The K1000’s shutter is fully mechanical, so every speed from 1s to 1/1000s and B works with a dead battery or no battery at all. Wikipedia describes the camera as completely operable without batteries.

Without a battery you lose just the meter needle. Use a phone light-meter app, a handheld meter or the sunny 16 rule, and keep shooting.

LR44 or SR44: does it matter?

Both fit and both work. The question is meter accuracy as the cell runs down.

  • Silver oxide (SR44) holds close to its full voltage for most of its life, then drops quickly at the end. Several Photrio forum members recommend it for the most consistent readings.
  • Alkaline (LR44) starts at a similar voltage but sags gradually. One Photrio member avoids alkalines in needle-meter cameras for that reason. Another says the K1000 has a voltage regulator, so it doesn’t matter. We haven’t found a published source for the regulator claim.

Our take: use an SR44 if you can. It costs a little more and removes one variable. An LR44 is fine to get you shooting, and if your negatives look good, there’s no need to change.

Where the battery goes and how to change it

The battery compartment is on the bottom plate, under a round cover with a coin slot.

  1. Unscrew the cover with a coin and lift it off.
  2. Remove the old cell.
  3. Check the contacts for green or white crust (see below).
  4. Fit the new cell with the + side facing out, toward the cover, as the manual shows.
  5. Screw the cover back on until it’s snug. Don’t overtighten.

How to check the battery

The K1000 has no battery-check button. The manual’s method:

  1. Set the shutter-speed dial to B and the film speed to ISO 100.
  2. Look through the finder at the meter needle.
  3. If the needle swings up and stays steady, the battery is good. If it barely moves, drifts down or doesn’t move, replace the cell.

If a fresh cell still gives no needle, clean the contacts. If the needle is stuck to one side even with no battery fitted, the meter movement itself is damaged. See the K1000 page for meter faults.

Keep the lens cap on

The K1000 has no meter on/off switch. Wikipedia says the meter draws power whenever light reaches it, so you should keep the lens cap on when you’re not shooting. A camera left uncapped on a shelf will run its battery flat.

Corrosion and storage

A cell left in for years can leak. JFR Film, a UK repairer, says leaked battery acid often kills the K1000’s meter by corroding the wiring, a repair it charges £50 for (price seen on its site, Nov 19, 2026).

  • Light corrosion on the contacts can usually be cleaned off gently.
  • A meter that stays dead after cleaning and a fresh cell may have corroded wiring inside.
  • Storing the camera? Take the battery out.

Other Pentax cameras using the same cell

Have Camera Will Travel and ausgeknipst both list the K1000 and KM as taking one LR44/SR44. Many later Pentax K-mount bodies use two of the same cells, including the MX, ME Super, LX, K2 and KX. So a pack of SR44s covers most of the Pentax range.

FAQ

What battery does the Pentax K1000 take? One 1.5V LR44 (alkaline) or SR44 (silver oxide) button cell. The 357, 303, S76 and A76 are the same size.

Does the Pentax K1000 need a battery to work? No. The battery only runs the light meter. The shutter works at every speed without it.

Is an LR44 the same as an SR44? Same size and nominal voltage, different chemistry. SR44 is silver oxide and holds its voltage more steadily. Both work in the K1000.

How do I know if my K1000 battery is dead? Set B and ISO 100 and look at the needle. If it doesn’t swing up and stay steady, replace the battery.

Why does my K1000 battery keep dying? There’s no meter switch. Keep the lens cap on when you’re not using the camera.

Where is the battery on a Pentax K1000? Under the round coin-slot cover on the bottom plate.

Cameras that use it

Sources

  1. Pentax K1000 instruction manual — Butkus.org
  2. Pentax K1000 — Wikipedia
  3. Pentax Camera Battery Compatibility Charts — Have Camera Will Travel
  4. Overview of batteries for Pentax analogue cameras — ausgeknipst
  5. Which battery for a Pentax K1000? — Photrio
  6. Pentax K1000 repairs and servicing — JFR Film

Last reviewed Nov 21, 2026.