Skip to content
lastroll

Nikon · SLR · 35mm

Nikon FE: Is It Worth Buying? Battery, Non-AI Lenses, Electronic Faults, FE vs FE2 and What to Check

Nikon FE buyer's guide: aperture-priority auto with a needle meter, the flip-up tab for non-AI lenses, LR44 cells and M90 backup, faults, FE vs FE2, and a checklist.

Reviewed Nov 20, 20267 min read

Is the Nikon FE worth buying?

Yes, if you want a compact Nikon that does aperture priority and still takes almost every Nikkor ever made. You set the aperture, and the FE picks a stepless shutter speed from 8s to 1/1000s. A black needle on the left of the finder shows the speed it chose. Switch to manual and you line up two needles, which tells you how far off you are, not just “over” or “under”.

What sets the FE apart is its flip-up meter coupling lever. Lock it up and you can mount pre-1977 non-AI lenses and meter stopped down. The FE2, FM2 and later bodies can’t take those lenses without conversion.

The catch is electronics. Without batteries, only the mechanical M90 (1/90s) and B work. After 40-plus years, the risks are electronic faults and worn resistor parts that repairers can no longer buy new. A good FE is very dependable; a flaky one can cost more to fix than to replace.

Buy one if you want aperture-priority auto, a needle meter and the widest Nikon lens compatibility. Skip it if you want a camera that works fully without batteries (get the Nikon FM) or you need 1/4000s and TTL flash (get the FE2).

Key specs

Spec Nikon FE
Type 35mm SLR
Made 1978–1983 (sold from dealer stock until about 1984, per Wikipedia)
Mount Nikon F; AI/AI-S at full aperture, non-AI by stop-down metering
Shutter Vertical-travel metal focal-plane, electronic; 8s–1/1000s manual and auto
Mechanical speeds M90 (1/90s) and B
Flash sync 1/125s; hot shoe with ready-light for the SB-10; no TTL flash
Exposure Aperture-priority auto; match-needle manual
Meter 60/40 center-weighted, two silicon photodiodes; EV 1–18 (ISO 100, f/1.4)
Film speed ISO 12–4000, set by hand
Compensation ±2 EV; memory lock on the self-timer lever
Finder Needle speed scale plus aperture readout window; interchangeable screens (K standard, B and E optional)
Battery 2 × SR44/LR44, or 1 × 3V lithium
Accessories MD-11 / MD-12 motor drive (up to 3.5 fps), MF-12 data back
Size / weight 142 × 89.5 × 57.5mm; 590g body

Ignore camera-wiki’s spec box, which gives 1s–1/2000s; its own text, the manual and Wikipedia all say 8s–1/1000s. Richard Haw writes that the FE’s ASA dial stops at 3200, but the manual and Nikon’s published spec sheet both say 12 to 4000, so we use that.

How it works

Turn the shutter-speed dial to the green AUTO setting (it clicks and locks there) and set the aperture. The advance lever is the meter switch: pull it out to its 30° stand-off position and the meter comes on. Push it flush against the body and the meter is off and the shutter release is locked.

  • AUTO: the black needle shows the speed the camera will use. The green needle sits at A.
  • Manual: the green needle shows the speed you set; turn the dial or the aperture until the two needles meet.
  • Memory lock: push the self-timer lever toward the lens and hold it. The exposure stays locked while you recompose, even though the black needle keeps moving, as Wikipedia points out.
  • M90 and B: mechanical. The manual says the shutter falls back to 1/90s at any setting when the batteries are dead.

Ken Rockwell notes, in both his review and his user’s guide, that using the self-timer flips the mirror up at the start of the countdown, which helps on a tripod. The FE has depth-of-field preview but no full-time mirror lock-up.

Battery

For more detail, see our Nikon FE and FE2 battery page.

The FE takes two 1.55V silver-oxide (SR44/S76) or 1.5V alkaline (LR44/A76) button cells, or one 3V lithium cell (CR-1/3N). They sit in a clip on the coin-slotted cap in the base. Unscrew it counterclockwise with a coin.

  • Battery check: push the battery-check lever down. If the lamp glows, the cells are good. If not, check how they’re seated, then replace them. Richard Haw warns that oxidized contacts can make the check unreliable, so fit fresh cells before you diagnose anything.
  • The big drain: leave the advance lever pulled out and the meter stays on. The manual warns this will completely drain the cells in a few days. Push the lever in when you put the camera down.
  • Without batteries: only M90 and B work. You can still shoot at 1/90s with a handheld meter or sunny 16.
  • Storage: take the cells out if the camera will sit unused, to prevent leakage.

Known issues

Mirror stuck up or shutter hanging open. Richard Haw says the mirror sometimes stays up when batteries are weak, so start with fresh cells. If the camera works on M90 and B but not on the electronic speeds with fresh cells, the fault is electronic and needs a repairer. On the Classic Camera Repair Forum, one owner cured a stuck-up mirror by pushing in a small sliding pin in a hole near the motor-drive coupling on the base. Try that before paying for a repair.

Jumpy or wrong meter needle. Haw says the resistor under the shutter-speed dial (Nikon calls it an FRE, functional resistance element) can get dirty and cause “jumpy-needle syndrome” or wrong speeds. A second FRE under the ASA dial can make the dial skip or read wrong. Both can be cleaned.

Broken aperture-coupling FRE. A third FRE reads the lens aperture. In Eugene Pate’s repair write-up, an FE with a dead meter, no auto speeds and a shutter hanging open on auto had a cracked FRE, which he says is no longer available from Nikon. Owners on the repair forum also point to the FRE as the cause of many FE problems. Treat a camera whose needle ignores the aperture ring as a parts body unless it’s priced that way.

Foam and seals. Haw replaces the foam around the meter cells and eyepiece because it crumbles, and the debris can get into the shutter. Back seals will be due on an unserviced body.

What to check on a used FE

  1. Power. Fit two fresh SR44s and push the battery-check lever. The lamp should light.
  2. Meter. Pull the advance lever out. Point at bright and dark areas: the black needle should move smoothly across the scale, not jump.
  3. Resistors. Turn the ASA dial and the lens aperture ring slowly. The needle should respond in even steps.
  4. Auto. On AUTO, fire at a slow reading (cover most of the lens) and a fast one. The mirror must come back down every time.
  5. Manual. Step through the speeds and check the green needle follows the dial.
  6. Coupling lever. Flip it up and back down. It should lock in both positions.
  7. Mechanical speeds. Take the batteries out and fire on M90 and B.
  8. Shutter and seals. Open the back. The blades should be clean and flat. Never touch them. Check the seals and battery chamber.

FE vs FE2

FE (1978) FE2 (1983)
Speeds 8s–1/1000s 8s–1/4000s
Flash sync 1/125s, no TTL 1/250s, TTL flash
Mechanical backup M90 and B M250 and B
Non-AI lenses Yes, flip-up coupling lever No (convert them first)
Meter switch Advance lever pulled out Half-press, stays on about 16s
Battery check Dedicated lever and lamp Needle behavior only

Buy the FE if you own or want old non-AI Nikkors. Ken Rockwell also says it uses about half the battery power of the FE2, whose faster shutter needs stronger springs and magnets. Buy the FE2 if you shoot flash or want 1/4000s.

Lenses

AI, AI-S, Series E and AF Nikkors with an aperture ring work normally (AF lenses focus by hand). Pre-AI lenses work with the coupling lever up and stop-down metering. G-type lenses have no aperture ring. Wikipedia warns never to mount IX-Nikkor (APS) lenses or the early 1960s fisheyes that need mirror lock-up, because their rear elements can hit the mirror.

Who it’s for, and alternatives

Good fit: anyone who wants aperture-priority auto with a precise needle display, and anyone with a bag of old non-AI Nikkors.

Not ideal: no-battery shooting, flash-heavy work, or program-mode fans.

  • Nikon FM: the FE’s mechanical twin. Every speed works without batteries; LED meter, no auto. Also takes non-AI lenses.
  • Nikon FE2: faster shutter and sync, TTL flash, AI lenses only.
  • Nikon FM2: mechanical with 1/4000s, AI lenses only.
  • Nikon EM: Nikon’s smaller, cheaper aperture-priority body. No manual mode, no depth-of-field preview, and AI lenses only, but it has the same M90 and B backup.
  • Pentax ME Super and Olympus OM-2: smaller aperture-priority bodies in other lens systems.
  • Minolta X-700: aperture priority plus program, but no mechanical speeds.

Used prices

Working copies (body only) sold on eBay US for about $50–$119 from Aug 22 to Nov 20, 2026. That is the middle half of 59 sales, item price before shipping, with parts-only and as-is listings left out.

FAQ

Does the Nikon FE work without batteries? Partly. M90 (1/90s) and B are mechanical. Auto, the meter and every other speed need power.

What battery does the Nikon FE take? Two SR44 or LR44 button cells, or one 3V CR-1/3N lithium cell.

Can the Nikon FE use non-AI lenses? Yes. Flip the meter coupling lever up before mounting, then meter stopped down with the depth-of-field preview lever.

Why does my Nikon FE battery die so fast? The advance lever is the meter switch. If it’s left pulled out, the meter stays on and drains the cells in days.

Nikon FE vs FE2: which should I buy? The FE for non-AI lenses and lower battery drain; the FE2 for 1/4000s, 1/250 sync and TTL flash.

Related cameras

Guides

Sources

  1. Nikon FE instruction manual — Butkus.org
  2. Nikon FE — Wikipedia
  3. Nikon FE — Camera-wiki.org
  4. Nikon FE Review — Ken Rockwell
  5. Repair: Nikon FE — Richard Haw's Classic Nikon Repair and Review
  6. Nikon FE (FRE) tutorial — Eugene Pate
  7. Nikon FE Meter/Shutter — Classic Camera Repair Forum
  8. Nikon FE specifications — York University Nikon reference
  9. Nikon FE user's guide — Ken Rockwell

Last reviewed Nov 20, 2026.