The short answer
The Nikon FM2 takes two 1.5V button cells in the SR44 / LR44 size, or one 3V lithium cell (CR-1/3N) in their place. Nikon’s manual lists all three:
| Chemistry | Names on the pack | How many | Voltage |
|---|---|---|---|
| Silver oxide | SR44, 357, 303, S76, EPX76 | 2 | 1.55V each, 3.1V together |
| Alkaline | LR44, A76 | 2 | 1.5V each, 3V together |
| Lithium | CR-1/3N | 1 | 3V |
The battery only powers the light meter. Wikipedia describes the FM2’s shutter as fully mechanical, so every speed from 1s to 1/4000s and B works with no battery at all.
Which should you buy?
SR44 silver oxide is the best choice for a meter. Ausgeknipst explains that an SR44 holds almost the same voltage for about 90% of its life, while an LR44 alkaline drops steadily toward 1.0V. For a meter that’s a steadier reading, longer.
LR44 alkaline is fine too. The manual lists it, it’s cheap and it’s sold everywhere.
CR-1/3N lithium is one cell the same size as two button cells stacked. Battery Equivalents gives its size as 11.6 × 10.8mm, the same as two LR44s. It’s handy, but harder to find in shops.
Whichever you pick, the manual says to change both cells at once, use the same make, and never mix old and new.
How to fit the batteries
From Nikon’s manual:
- Use a coin to unscrew the battery chamber lid on the baseplate, counterclockwise.
- Wipe the battery terminals clean.
- Insert the cells with the + signs facing up.
- Screw the lid back in clockwise.
Don’t over-tighten. A Photo.net owner found the meter wouldn’t come on with fresh cells until they left the lid finger-tight. On some bodies, cranking it down with a coin can upset the contact.
How to check the battery
The FM2 has no separate battery check button. The manual says:
- Pull the advance lever out slightly to the standoff position. That unlocks the shutter release.
- Press the shutter release lightly while looking through the finder. This switches the meter on.
- One or two of the red LEDs should light. That means the battery is fine.
- If no LED lights, the cells are dead or fitted wrongly. (With the speed dial on B, no LEDs light, so set a normal speed first.)
The meter switches off about 30 seconds after you let go of the button.
Cold weather and storage
The manual’s battery tips:
- Cold: battery power falls off in very cold weather and the meter can misbehave. Use fresh cells and keep the camera warm. Power comes back once the camera warms up. Because the shutter is mechanical, you can keep shooting either way.
- Storage: take the batteries out if you won’t use the camera for a long time.
- Leaks: if you find a stain from a leaking cell, take it out at once and clean the chamber.
- Spares: check the cells before a shoot and carry spares for a long day.
- Life: Nikon gives about a year.
Meter dead with fresh batteries?
Try the cheap fixes first:
- Loosen the lid to finger-tight.
- Clean the cell faces and contacts with a dry cloth.
- Try a different pair of fresh cells.
If none of that works, the fault is in the wiring under the bottom plate or the meter circuit. Our Nikon FM2 page covers that.
Other Nikons that take the same cells
The Nikon FM, FE, FE2, F3 and FM10 all use two SR44 / LR44 cells (or one CR-1/3N on most). The FE, FE2 and F3 have electronic shutters, so on those the battery matters much more. See our LR44 vs SR44 vs 357 guide for what the names on the pack mean.
FAQ
What battery does the Nikon FM2 take? Two 1.5V SR44 (silver oxide) or LR44 (alkaline) cells, or one 3V CR-1/3N lithium.
Does the Nikon FM2 work without a battery? Yes. The shutter is mechanical. Only the meter needs power.
How do I check the battery on an FM2? Pull the advance lever out, press the shutter release lightly and look for a red LED in the finder. No LED means flat or badly fitted cells.
LR44 or SR44 for the FM2? Both work. SR44 holds a steadier voltage for the meter; LR44 is cheaper.
How long do FM2 batteries last? Nikon’s manual says about a year.